INTRODUCTION :
Agamero Solar Road Studs, also known as cat eyes, have been proven to significantly reduce accidents at regional rail crossings and intersections. These studs provide guidance and hazard warnings to drivers in darkness and adverse weather conditions.
The solar system of solar-powered road studs is environmentally friendly and cost-effective, making them the perfect solution for road safety. Our company’s LED road studs are produced with over 5 years of factory experience. They offer a competitive price and a wide range of options to the global traffic road safety market.
Agamero product features an aluminum alloy metal shell with a compression index of more than 30 tons. The design of reflectors is sunken in the aluminum shell, protecting them perfectly when a vehicle runs over the road studs. The solar-powered road studs are available with or without shanks, and the working principle is straightforward.
Working Principle of Agamero Solar Road Stud Light:
During the day, solar panels absorb sunlight and convert it into electrical energy, which is stored in energy storage devices such as batteries or capacitors. At night, the electrical energy in the energy storage devices is automatically converted into light energy, controlled by photoelectric switches and emitted by LEDs.
The bright light outlines the road and induces the driver’s sight. The solar road studs will start to flash automatically when night falls or with the onset of inclement weather. The flashing LEDs are highly effective in getting the attention of drivers much earlier than conventional road studs.
Installation Method Of Raised Agamero Solar Road Stud:
- To avoid an adverse effect on the ground, mark the distance between the placement of solar road stud lights. Use a proper tool such as Core Drill, drill Φ35mm and depth to be 55mm. Remove all debris from the installation hole, then pour epoxy into the holes per the manufacturer’s instructions.
- Verify that the installation hole is straight and large enough to allow epoxy to surround the solar-led road stud shaft. Set the lighting surface of the solar road stud to the desired viewing angle.
- Verify that the epoxy is evenly adhering to the installation hole and solar marker shaft. Confirm that the bottom of the solar road marker is firmly installed on the installation surface, allowing for zero “surface float” to occur (space between the installation surface and the bottom of the solar marker).
- After curing the LED solar road stud for 6-8 hours, remove the installation of the isolation facility.
Recommended Spacing between Agamero Solar Road Studs:
- Highways and Expressways: 7-8 yards (5-6 meters)
- Dangerous Entrances and Exits: 4-5 yards (2-3 meters)
- Access or Exit ways for Hospitals, Parking Lots, etc.: 0.5-3 yards (0.5-2 meters)
The spacing between each solar studs varies according to your actual application requirements.
Agamero Solar Road Stud Characteristics:
- High-brightness LED light that lasts up to 100,000 hours.
- USA brand solar panel with a 22% high conversion rate and fast charge rate.
- Japan brand casting Al material that bears more pressure.
- Top-quality epoxy resin glue fixes the solar stud, ensuring the solar power charge.
- Philips PC board that is safe and stable, providing a long time warranty for road stud reflectors.
- The leader of solar road studs, with a load capacity of over 30T (can be installed in the middle of the road).
Reviews
There are no reviews yet.